LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Charging System) >> Repair Instructions >> Generator Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Idler Pulley, Generator And Mounting Bolts
G04843526Courtesy of SUZUKI OF AMERICA CORP.
  1. Position the generator to the engine.
  2. Loosely install the generator bolts.
  3. Install the idler pulley. Refer to INSTALLATION PROCEDURE .
    CAUTION: Refer to FASTENER NOTICE .
  4. Tighten the generator bolts in the sequence shown in Fig 2.

    Tightening torque 

    Tighten the bolts to 50 N.m (37 lb ft). 

    Fig 2: Engine Harness Electrical Connector And Generator
    G04843527Courtesy of SUZUKI OF AMERICA CORP.
  5. Install the drive belt. Refer to INSTALLATION PROCEDURE .
  6. Connect the engine harness electrical connector to the generator.
    Fig 3: Battery Cable Terminal, Nut And Generator
    G04843528Courtesy of SUZUKI OF AMERICA CORP.
  7. Install the positive battery cable terminal to the generator.
  8. Install the positive battery cable nut at the generator.

    Tightening torque 

    Tighten the nut to 20 N.m (15 lb ft). 

  9. Position the positive battery cable boot at the generator terminal.
  10. Connect the negative battery cable. Refer to INSTALLATION PROCEDURE .
scientia non olet · About LEMON Manuals