LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Grand Vitara Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Body Electrical Control System >> Diagnostic Information and Procedures >> Scan Tool Data >> Scan Tool Data Definitions
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Scan Tool Data Definitions

Outside Air Temp (°C, ° F)  It is detected by outside air temperature sensor.
Battery Voltage (V)  This parameter indicates battery positive voltage inputted to BCM.
LED Illumi Contrast (Dimmer control ratio of LED) (%)  This parameter indicates illumination control percent computed by BCM. (This parameter depends on the illumination control switch position)
Bulb Illumi Contrast (Dimmer control ratio of bulb) (%)  This parameter indicates illumination control percent computed by BCM. (This parameter depends on the illumination control switch position)
Auto Light Sensor (V)  This parameter indicates auto light sensor voltage inputted to BCM.
Vehicle Speed (km/h, mph)  This parameter indicates the vehicle speed computed by ECM.
Engine Speed (RPM)  This parameter indicates the engine speed computed by ECM.
Driv Door SW (Driver door switch) (Open/Close)  This parameter indicates the state of the driver side door switch.
Pass Door SW (Passenger, rear side and rear end door switch) (Open/Close)  This parameter indicates the state of the door switches other than driver side door switch.
Auto Light SW (Auto light switch) (ON/OFF)  This parameter indicates the state of the auto light switch.
Front Fog Light SW (Front fog light switch) (ON/OFF)  This parameter indicates the state of the front fog light switch.
Door key SW (Lock) (Door key cylinder switch (lock side)) (ON/OFF)  This parameter indicates the state of the door key cylinder switch.
Door key SW (Unlock) (Door key cylinder switch (unlock side)) (ON/OFF)  This parameter indicates the state of the door key cylinder switch.
Door Lock SW (Manual door lock switch (lock side)) (ON/OFF)  This parameter indicates the state of the manual door lock switch.
Door Unlock SW (Manual door lock switch (unlock side)) (ON/OFF)  This parameter indicates the state of the manual door lock switch.
Key Reminder SW (Key reminder switch) (Pulled/Key in)  This parameter indicates the state of the key reminder switch.
Headlight SW (Headlight switch) (ON/OFF)  This parameter indicates the state of the lighting switch.
Tail Light SW (Lighting switch) (ON/OFF)  This parameter indicates the state of the lighting switch.
Driv Seat belt SW (Driver seat belt switch) (Fasten/Unfasten)  This parameter indicates the state of the driver side seat belt buckle switch.
Brake Fluid Level (Low/Normal)  Low: Brake fluid level is lower than specified level.
Normal: Brake fluid level is higher than MIN level.
Parking Brake SW (Parking brake switch) (ON/OFF)  ON: Parking brake lever is pulled up.
OFF: Parking lever is released.
Charge Light (ON/OFF)  This parameter indicates the state of the charge system monitor switch.
Oil Pressure SW (ON/OFF)  This parameter indicates the state of the oil pressure switch.
A/C SW (ON/OFF)  This parameter indicates the state of the air conditioning switch.
Ignition 1 Switch (Ignition switch ON position) (ON/OFF)  This parameter indicates the state of the ignition switch.
ACC Switch (Ignition switch ACC position) (ON/OFF)  This parameter indicates the state of the ignition switch.
Rear Wiper ON SW (Rear wiper ON switch) (ON/OFF)  This parameter indicates the state of the rear wiper switch.
Rear Wiper INT SW (Rear wiper INT switch) (ON/OFF)  This parameter indicates the state of the rear wiper switch.
Rear Washer SW (Rear washer switch) (ON/OFF)  This parameter indicates the state of the rear washer switch.
Security Alarm (Active/Passive)  Active: Security alarm at "Active" mode.
Passive: Security alarm at "Inactive" mode.