Resetting after Replacing Front Window Regulator Assembly
- Push engine switch to change ignition mode of keyless start system to "ON" (with vehicle stopped).
- Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 7 seconds.
- Push down and hold power window switch until window glass reaches its fully open position (lowest position) and continue holding it down for about 2 seconds.
- Release power window switch temporarily and then press down and hold the power window switch again for approximately 5 seconds at Auto DOWN position.
- Pull up and hold power window switch in AUTO position until window glass reaches its fully closed position and continue holding it up for about 2 seconds.
- Perform Auto DOWN and Auto UP operations to check that door glass can be opened and closed fully. Repeat procedure from Step 1) if Auto DOWN or Auto UP function does not work.
- Check anti-pinching function, see INSPECTION OF POWER WINDOW ANTI-PINCHING FUNCTION .