Module - Restraint Control (Structural Pack) - Remove And Replace: Notes
WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
Last modified: 24/08/2023 13:40:23
NOTE:
See PERSONAL PROTECTION
to make sure wearing proper PPE when performing the below procedure.
Revision History:
- 2023-08-24: Added additional warning to make sure LV is disconnected.
- 2023-04-25: Updated TBX routines for Restraint Control Module version 12.1.
WARNING:
Make sure 12V/LV power has been disconnected for at least 2 minutes before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see AIRBAG AND SUPPLEMENTARY RESTRAINT SYSTEM (SRS) PRECAUTIONS
WARNING:
Supplementary Restraint System (SRS) components can be hazardous if not handled properly. For more information on SRS precautions, see AIRBAG AND SUPPLEMENTARY RESTRAINT SYSTEM (SRS) PRECAUTIONS
WARNING:
While performing any Supplementary Restraint System (SRS) related repairs, it is important to disconnect 12V/LV power. If the vehicle's 12V/LV power is NOT disconnected and the Restraint Control Module is removed or disturbed, this can result in the deployment of the vehicle's airbags.