Module - Body Controller - BCM - Remove And Replace: Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Tesla Model S, 2019 Tesla Model S, 2018 Tesla Model S, 2017 Tesla Model S, and 2016 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Configuration changes from within Toolbox can only be performed by a Tesla employee at this time. Third parties must request the configuration change through their agreed Tesla technical support channel.
Installation procedure is the reverse of removal, except for the following:
- Reinstall the latest vehicle firmware, or update the firmware if not the latest. See Firmware Reinstall - Touchscreen or Firmware Update .
- For the body controller, in Toolbox 3, click the Actions tab, type "PROC-BDY" into the search field, click PROC_BDY_X_BDY-PEKTRON-VIN-LEARN, click Run , and allow the routine to complete.
- For the security controller, in Toolbox 3, click the Actions tab, type "PROC-SEC" into the search field, click PROC_SEC_X_PEKTRON-VIN-LEARN, click Run , and allow the routine to complete.
- Relearn all keys. Refer to Key Fob - Program .
- For early Model S vehicles, in Toolbox 3, click the Actions tab, type "immobilizer reset" into the search field, click PROC_DI_X_IMMOBILIZER-RESET, click Run , and allow the routine to complete.