Test 12: Throttle Position Sensor IDL Signal
NOTE:
Ensure throttle position sensor adjustment and operation are normal. See TESTS W/CODES
in the ENGINE PERFORMANCE section. Adjust or replace throttle position sensor as necessary.
- On models with motor actuator, connect Throttle Position Sensor (TPS) connector and disconnect CC ECU connector. Release accelerator pedal and ensure continuity exists between ground and CC ECU connector terminal No. 23 (Green/White wire).
- If continuity is present, go to next step. If continuity is not present, repair open in harness between CC ECU connector terminal No. 23 or No. B9 and terminal No. 2/IDL of 4-pin throttle position sensor connector (Green/White wire).
- Depress accelerator pedal and ensure no continuity exists between ground and CC ECU connector terminal No. 23 (Green/White wire). If continuity is not present, replace CC ECU and retest system. If continuity is present, repair short in harness between CC ECU connector terminal No. 23 or No. B9 and terminal No. 2 of 4-pin throttle position sensor connector.