LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 1994 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition System: Distributor: Removal

  1. Disconnect negative battery cable. Disconnect distributor electrical connector. Set No. 1 cylinder to TDC of compression stroke. Turn crankshaft pulley until timing mark aligns with "0" mark on timing chain cover. Verify distributor rotor position is at about 11 o'clock. If rotor is not in proper position, rotate crankshaft one complete revolution until marks are aligned. See Figure.
  2. Remove distributor cap with spark plug wires attached. Remove distributor hold-down bolt. Remove distributor. Remove "O" ring from distributor shaft and discard.
scientia non olet · About LEMON Manuals