Section 5 (Engine Controls - Remove/Install/Overhaul): Introduction
WARNING: This page is about a different car, the 1994 Toyota Paseo. However, it is still accessible from the selected car via links, so may be relevant.
Removal, overhaul and installation procedures are covered in this article. If component removal and installation is primarily an unbolt and bolt-on procedure, only a torque specification may be furnished.
CAUTION:
When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. If vehicle is equipped with air bag(s), after disconnecting negative battery cable, wait a minimum of 2 minutes before working on vehicle.