Code Detection Test Drive
- Ensure ignition is off. Remove EFI (15 amp) fuse for at least 10 seconds. Connect jumper wire between DLC2 terminals TE2 and E1. See Figure. Start engine and warm to normal operating temperature.
- Drive vehicle at 50-55 MPH for 10 minutes or more. Stop vehicle and allow to idle for 2 minutes or less. Accelerate vehicle to 60 MPH with throttle fully open (WOT). If malfunction exists, MIL will illuminate while accelerating under full throttle.
NOTE:
When diagnosing ECM circuits, manufacturer recommends using test harness (09990-01000).