Wireless Door Lock Control Receiver
- Turn ignition off. Remove wireless door lock control receiver. Test specified terminals (backprobe) with wireless door lock control receiver 7-pin harness connector, connected and specified tests with harness connector disconnected. See TESTING WIRELESS DOOR LOCK CONTROL RECEIVER . See Fig 1. Replace wireless door lock control receiver if values are not as specified.
WIRELESS DOOR LOCK CONTROL RECEIVER TEST
| Check Between Ground & Terminal No. | Condition | Specified Value | |
|---|---|---|---|
| Wiring Harness Disconnected | |||
| 1 | Continuous | Battery Voltage | |
| 7 | Continuous | Continuity | |
| Wiring Harness Connected | |||
| 2 | Normal Mode | 10-14 Volts | |
| 2 | Code Registration Mode | Below 1 Volt | |
| 4 | Ignition OFF, Key Removed, Transmitter ON | About 6-7 Volts | |