Headlight Control Switch

Remove necessary steering column covers for access to headlight control switch. See Figure. Disconnect 13-pin electrical connector from headlight control switch.

Using ohmmeter, check that no continuity and continuity between specified electrical terminals on headlight control switch in relation to headlight control switch position. See HEADLIGHT CONTROL SWITCH CONTINUITY table. See Fig 1. Replace headlight control switch if defective. See HEADLIGHT CONTROL SWITCH under REMOVAL & INSTALLATION.

HEADLIGHT CONTROL SWITCH CONTINUITY

Switch Position

Switch Terminals No.

Specification

OFF

⁽¹⁾

TAIL

10 & 13

Continuity

HEAD

10 & 13; 11 & 12

Continuity

LOW BEAM

8 & 11

Continuity

HIGH BEAM

9 & 11

Continuity

FLASH

9 & 11

Continuity

⁽¹⁾	There should be no continuity between any terminals.

Fig 1: Identifying Headlight Control Switch Electrical Terminals & Headlight Control Switch Positions