Section 374 (Air Conditioning System): Receiver: Installation

WARNING: This page is about a different car, the 2002 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL RECEIVER
1. Install the receiver to the holder with bolt.
  
  Fig 1: Installation (1 Of 3)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  If receiver is replaced, add compressor oil to receiver.
  
  Add 20 cc (0.71 fl.oz.)
  
  Compressor oil: ND-OIL 8 or equivalent
2. Install the receiver to condenser with 2 bolts.
  
  Fig 2: Installation (2 Of 3)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT 2 LIQUID TUBES
1. Lubricate 2 new O-rings with compressor oil and install them to the tubes.
  Compressor oil: ND-OIL 8 or equivalent
2. Connect the both tubes with 2 bolts.
  Torque: 5.4 N.m (56 kgf.Cm, 48 in.lbf)
  
  Fig 3: Installation (3 Of 3)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CHARGE SYSTEM WITH REFRIGERANT
1. Evacuate air from refrigeration system.
2. Charge system with refrigerant.
Specified amount: 800 +/- 50 g (28.22 +/- 1.76 oz.)
INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant. if there is leakage, check the tightening torque at the joints.