Specifications Index
HIGHLANDER SPECIFICATIONS INDEX
| System | Specifications/Procedures | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | |||
| Automatic | SPECIFICATIONS | ||
| Manual | SPECIFICATIONS | ||
| Torque | |||
| Automatic | TORQUE SPECIFICATIONS | ||
| Manual | TORQUE SPECIFICATIONS | ||
| Axle Shaft Nut/Lock Nut | |||
| Front | 217 ft.lbs (294 N.m) | ||
| Rear | 159 ft.lbs (216 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | |||
| 2.4L (2AZ-FE) | ON-VEHICLE INSPECTION | ||
| 3.0L (1MZ-FE) | ON-VEHICLE INSPECTION | ||
| Torque | |||
| 2.4L (2AZ-FE) | TORQUE SPECIFICATIONS | ||
| 3.0L (1MZ-FE) | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | |||
| 2.4L (2AZ-FE) 3.0L (1MZ-FE) |
Standard opening pressure: 13.4-17.6 psi (.95-1.25 kg/cm2
) (Minimum opening pressure: 11.2 psi (0.78 kgf/cm2 )) |
||
| Thermostat R & I | |||
| 2.4L (2AZ-FE) | THERMOSTAT (2AZ-FE) | ||
| 3.0L (1MZ-FE) | THERMOSTAT (1MZ-FE) | ||
| Water Pump R & I | |||
| 2.4L (2AZ-FE) | WATER PUMP ASSY (2AZ-FE) | ||
| 3.0L (1MZ-FE) | THERMOSTAT (1MZ-FE) | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| 2.4L (2AZ-FE) | Oil pressure should be at least 4.3 psi (0.3 kg/cm2
) or more at idle and 36-75 psi (2.5-5.2 kg/cm2
) or more at 3000 RPM. (At normal operating temperature) |
||
| 3.0L (1MZ-FE) | Oil pressure should be at least 4.3 psi (0.3 kg/cm2
) at idle and 43-78 psi (3.0-5.5 kg/cm2
) at 3000 RPM. (At normal operating temperature) |
||
| Overhaul | |||
| 2.4L (2AZ-FE) | SPECIFICATIONS | ||
| 3.0L (1MZ-FE) | ENGINE SPECIFICATIONS | ||
| Torque Specifications | |||
| 2.4L (2AZ-FE) | TORQUE SPECIFICATIONS | ||
| 3.0L (1MZ-FE) | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab | ||
| Flywheel/Flex Plate (Drive Plate) Torque | |||
| 2.4L | |||
| Automatic Transmission | 72 ft.lbs (98 N.m) | ||
| Manual Transmission | NA | ||
| 3.0L | |||
| Automatic Transmission | 61 Ft.lbs. (83 N.m) | ||
| Manual Transmission | 61 Ft.lbs. (83 N.m) | ||
| Fuel System | |||
| Pressure | |||
| 2.4L (2AZ-FE) 3.0L (1MZ-FE) |
44-50 psi (3.1-3.5 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | |||
| 2.4L (2AZ-FE) | HIGHLANDER & RAV4 | ||
| 3.0L (1MZ-FE) | CAMRY & HIGHLANDER | ||
| Fuel Filter Locations | |||
| 4 Cyl | FUEL FILTER | ||
| V6 & V8 | FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plugs | |||
| Type Gap Torque |
SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | Refer to applicable components in PROCEDURES under WHEEL ALIGNMENT. | ||
| Wheel & Tire | |||
| Lug Nut Torque | 76 ft.lbs. (103 N.m) | ||