Section 495 (Rear Brake Speed Sensor): Disassembly

WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

2WD:

REMOVE ABS SPEED SENSOR

Using a pin punch and hammer, drive out the 2 pins, and remove the 2 attachments from SST.
SST 09520-00031 (09520-00040, 09521-00020)
Mount the axle hub assembly in a soft jaw vise.
NOTE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.
Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the ABS speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020

Fig 1: Removing ABS Speed Sensor From Axle Hub
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
- Do not allow any foreign matter to stick to the sensor rotor.
- Pull out the ABS speed sensor straightly not to damage the sensor rotor.
- If the sensor rotor is damaged, replace the axle hub assembly.
- Do not scratch the contacting surface of the axle hub and speed sensor.