LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 968 (Door System - Front) >> Window Regulator >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Window Regulator: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert front guide rail through front access hole (Figure ).
  2. Insert rear guide rail through rear access hole.
  3. Place window regulator in position on inner door panel.
    Fig 1: Removing Power Window Regulator
    G03571645Courtesy of DAIMLERCHRYSLER CORP.
  4. Place screw heads on guide rails in position through key hole slots in inner door panel.
  5. Tighten screws to attach front and rear guide rails to inner door panel to 9 N.m (80 in. lbs.).
  6. Tighten screws to attach motor/housing to inner door panel to 3 N.m (27 in. lbs.).
  7. Connect wire connector into power window motor (Fig 1 ).
  8. Install door glass. (Refer to INSTALLATION  ).
  9. Verify door glass alignment and operation.
  10. Install inner belt molding. (Refer to FRONT INNER BELT MOLDING WEATHERSTRIP ).
  11. Install watershield. (Refer to INSTALLATION  ).
  12. Install door trim panel. (Refer to INSTALLATION  ).
scientia non olet · About LEMON Manuals