Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the combination meter operates.

   COMBINATION METER: 

   ACTIVE TEST
   
   

   Tester Display	Description	Check Condition
   CRUISE INDIC	"CRUISE" indicator is ON / OFF	ON - OFF

   OK: 

   Indicator light comes on. 

NG: REPLACE COMBINATION METER 

OK: Go to Next Step 

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch on, and turn the intelligent tester main switch on (IG).
3. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   CC (ECM): 

   DATA LIST
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   CCS READY M	Cruise control system standby condition (Main CPU) / ON or OFF	Each time main switch is pushed, ON is displayed and then OFF is displayed	A
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	B

   OK: 

   When cruise control main switch operation is performed, the result will be same as above. 

   HINT:

   A is OK, but B is NG --> DTC output or hybrid vehicle control ECU failure

NG: REPLACE ECM 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE