Data List/Active Test
WARNING: This page is about a different car, the 2006 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- DATA LIST
- While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.
CC (ECM):
DATA LISTItem Measurement Item/Display (Range) Normal Condition Diagnostic Note VEHICLE SPD Vehicle speed/min.: 0 km/h (0mph), max.: 255 km/h (158 mph) Actual vehicle speed - MEMORY SPD Memory vehicle speed/min.: 36 km/h (22.5 mph), max.: 200 km/h (125 mph) Actual stored vehicle speed - THROTTLE Throttle opening angle/min.: 0°, max.: 125° Actual required throttle opening - CRUISE CONTROL Cruise control system active condition/ON or OFF ON: Cruise control activated
OFF: Cruise control inactivated- MAIN SW (MAIN) Main SW signal (Main CPU)/ON or OFF ON: Main SW ON (Pushed on)
OFF: Main SW OFF (Pushed off)"3" MAIN SW (SUB) Main SW signal (Sub CPU)/ON or OFF ON: Main SW ON (Pushed on)
OFF: Main SW OFF (Pushed off)"3" CCS READY M Cruise control system standby condition (Main CPU)/ON or OFF ON/OFF: Change ON/OFF each time main switch is pushed in. "1" CCS READY S Cruise control system standby condition (Sub CPU)/ON or OFF ON/OFF: Change ON/OFF each time main switch is pushed in. "1" CCS INDICATOR M Cruise indicator signal (Main CPU)/ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CCS INDICATOR S Cruise indicator signal (Sub CPU)/ON or OFF ON: "CCS READY" ON
OFF: "CCS READY" OFF"2" CANCEL SW CANCEL SW signal/ON or OFF ON: CANCEL SW ON
OFF: CANCEL SW OFF- -/SET SW -/SET SW signal/ON or OFF ON: -/SET SW ON
OFF: -/SET SW OFF- +/RES SW +/RES SW signal/ON or OFF ON: +/RES SW ON
OFF: +/RES SW OFF- STP LIGHT SW2 M Stop light SW signal (Main CPU)/ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW2 S Stop light SW signal (Sub CPU)/ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- STP LIGHT SW1 S Stop light SW signal (Sub CPU)/ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released- SHIFT D POS PNP SW signal (D position)/ON or OFF ON: Shift D position
OFF: Except shift D position- HINT:
"3" is OK but "1" is NG -> ECM failure
"1" is OK but "2" is NG -> DTC output or ECM failure
"3" is OK but the cruise indicator does not come on -> CRUISE main indicator, wire harness or ECM failure
- While the intelligent tester is connected to the DLC3 with the ignition switch in the ON position, the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.