Diagnostic Trouble Code Chart
HINT:
- Using SST 09843-18040, connect terminal TC and CG of DLC3.
- If a malfunction code is displayed during the DTC check, check the circuit listed for that code. For details of each code, refer to under respective "DTC No." in DIAGNOSTIC TROUBLE CODE CHART .
DYNAMIC LASER CRUISE CONTROL SYSTEM
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | Detection Item | Trouble Area |
|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction |
|
| P0503 | Vehicle Speed Sensor Circuit Malfunction |
|
| P0571 | Brake Switch "A" Circuit |
|
| P0571 | Stop Light Switch Circuit Malfunction |
|
| P0607 | Control Module Performance | ECM (This DTC indicates a malfunction in the ECM. When this DTC is output, it is necessary to replace the ECM.) |
| P1570 | Radar Sensor Malfunction | Laser radar sensor |
| P1572 | Improper Aiming of Radar Sensor Beam Axis | Laser radar sensor |
| P1575 | Warning Buzzer Malfunction |
|
| P1578 | Brake System Malfunction | VSC system |
| P1615 | Communication Error from Distance Control ECU to ECM |
|
| P1616 | Communication Error from ECM to Distance Control ECU |
|
| U0100 | Lost Communication with ECM/PCM "A" |
|
| U0122 | Lost Communication with Vehicle Dynamics Control Module |
|
| U0235/71 | Communication Error from Laser Radar Sensor to Distance Control ECU |
|
| U0235/72 | Communication Error from Distance Control ECU to Laser Radar Sensor |
|
HINT:
*: When DTC P1578 (69) is output, check the DTCs on the skid control ECU in the diagnosis mode. Only when any code is output, inspect the trouble area based on following the DTC.