LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> 4Runner Limited, 4.7 T, AWD >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield/Window Glass >> Power Window Control System >> Manual Up / Down Function does not Operate on Passenger Side Only >> Inspection Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection Procedure

  1. CHECK WIRE HARNESS (POWER SOURCE) 
    1. Disconnect the P9 switch connector.
      Fig 1: Identifying P9 Connector Terminals
      G04967126Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the ignition switch ON.
    3. Check the voltage between terminal 4 of the wire harness side connector of the switch and the body ground.

      Standard voltage: 10 to 14 V 

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (SWITCH - RELAY) 

    OK: GO TO NEXT STEP 

  2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (PASSENGER SIDE) 
    1. Remove the power window switch.
    2. Check the continuity between the terminals of the switch connector when the switch is operated.
      Fig 2: Identifying Power Window Regulator Switch Assembly (Passenger Side) Connector Terminals
      G04967127Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      POWER WINDOW REGULATOR SWITCH ASSEMBLY (PASSENGER SIDE)

      Terminal No. Switch Specified Condition
      1-2, 3-4 UP Continuity
      1 - 2, 3 - 5 OFF
      1-4, 3-5 DOWN

    NG: REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY 

    OK: GO TO NEXT STEP 

  3. CHECK WIRE HARNESS (SWITCH - MOTOR) (SWITCH - BODY GROUND) 
    1. Disconnect the P13 motor connector.
    2. Check the continuity between the wire harness side connectors.
      Fig 3: Identifying P9 And P13 Connector Terminals
      G04967128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      SWITCH - MOTOR

      Terminal No. Specified Condition
      P9-1 -P13-1 Continuity
      P9-3 -P13-2
    3. Check the continuity between the P9 switch connector and the body ground.

      Standard resistance 

      SWITCH - BODY GROUND

      Terminal No. Specified Condition
      P9-1 - Body ground No continuity
      P9-3 - Body ground

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: GO TO NEXT STEP 

  4. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 
    1. Remove the motor.
    2. Apply battery voltage to connector terminals 1 and 2.
    3. Check that the motor rotates smoothly.
      Fig 4: Inspecting Power Window Regulator Motor Assembly RH
      G04967129Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard 

      POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

      Terminal No. Specified Condition
      Battery positive (+) → 1
      Battery negative (-) → 2      		 Motor gear rotates clockwise
      Battery positive (+) → 2
      Battery negative (-) → 1      		 Motor gear rotates counterclockwise

    NG: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

    OK: REPAIR OR REPLACE HARNESS OR CONNECTOR (MASTER SWITCH - SWITCH) 

scientia non olet · About LEMON Manuals