Inspection Procedure

1. Disconnect the H6 connector.
2. Measure the resistance and voltage according to the value(s) in the table below.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   H6-1 (E) - Body ground	Always	Below 1 Ω

   Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   H6-7 (BW) - Body ground	Always	10 to 14 V
   H6-6 (B) - Body ground	Always	10 to 14 V
   H6-11 (IG) - Body ground	Ignition switch OFF Ω ON	0 V Ω 10 to 14 V

Fig 1: Identifying H6 Multiplex Network Master Switch Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE