Inspection Procedure

1. Remove the switch.
2. Measure the resistance of the switch when the switch is operated.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Switch Condition	Tester Connection	Specified Condition
   UP	1 (D) - 2 (SD) 3 (U) - 4 (B)	Below 1 Ω
   OFF	1 (D) - 2 (SD) 3 (U) - 5 (SU)	Below 1 Ω
   DOWN	1 (D) - 4 (B) 3 (U) - 5 (SU)	Below 1 Ω

Fig 1: Identifying J2 Power Window Regulator Switch Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (REAR LH) 

OK: PROCEED TO NEXT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE