Power Window Control System: Removal: Notes

HINT:

A bolt without a torque specification is shown in the standard bolt chart.

1. REMOVE FR WIPER ARM RH  (See REMOVAL )
2. REMOVE FR WIPER ARM LH  (See REMOVAL )
3. REMOVE HOOD TO COWL TOP SEAL  (See REMOVAL )
4. REMOVE COWL TOP VENTILATOR LOUVER LH  (See REMOVAL )
5. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
6. REMOVE FRONT DOOR WEATHERSTRIP RH 
7. REMOVE FRONT DOOR WEATHERSTRIP LH 
8. REMOVE FRONT PILLAR GARNISH RH  (See REMOVAL )
9. REMOVE FRONT PILLAR GARNISH LH 
10. REMOVE INNER REAR VIEW MIRROR ASSEMBLY  (See REMOVAL )
11. REMOVE RH VISOR ASSEMBLY  (See REMOVAL )
12. REMOVE LH VISOR ASSEMBLY 
13. REMOVE MAP LAMP ASSEMBLY  (See REMOVAL )
14. REMOVE ASSIST GRIP SUB-ASSEMBLY  (See REMOVAL )
15. REMOVE VISOR HOLDER  (See REMOVAL )
16. REMOVE ROOF HEADLINING ASSEMBLY  (See REMOVAL )
17. REMOVE ROOF DRIP SIDE FINISH MOLDING CENTER RH 
18. REMOVE ROOF DRIP SIDE FINISH MOLDING CENTER LH 
19. REMOVE WINDSHIELD MOLDING OUTSIDE 
    1. Using a knife, cut off the molding as shown in the illustration.
       NOTE: Do not damage the vehicle body with the knife.
    2. Remove the remaining molding.

       HINT:

       Make a partial cut in the molding.

    Fig 1: Cutting Off Molding Using Knife

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
20. REMOVE WINDSHIELD GLASS 

    HINT:

    Depending on a vehicle type, either a 1-piece type or a 2-piece type of stopper is installed.

    1. From the interior, insert a piano wire between the vehicle body and glass.

       HINT:

       Apply protective tape to the outer surface of the vehicle body to keep the surface from being scratched.

       Fig 2: Identifying Protective Tape To Outer Surface In Windshield Glass

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Tie both wire ends to wooden blocks or similar objects.
       NOTE: When separating the glass, take care not to damage the paint and interior/exterior ornaments.
    3. Cut the adhesive by pulling the piano wire around the glass.
    4. Using a suction cup, remove the glass.
    NOTE: Leave as much adhesive on the body as possible when removing the glass.
    Fig 3: Pulling Piano Wire Around Glass

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
21. CLEAN WINDSHIELD GLASS 
    1. Using a scraper, remove the damaged stoppers, dam and adhesive sticking to the glass.
    2. Clean the outer edge of the glass with white gasoline.
    NOTE: Do not touch the glass after cleaning it.
    Fig 4: Cleaning Windshield Glass

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002