Combination Meter: Installation

INSTALL COMBINATION METER ASSEMBLY
1. Connect the 2 connectors and the clamp.
  
  Fig 1: Identifying Combination Meter Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter assembly with the 4 screws.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 2: Identifying Combination Meter Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL (See INSTALLATION )
INSTALL LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT PANEL GARNISH LH (See INSTALLATION )
INSTALL COWL SIDE TRIM BOARD LH
1. Engage the 2 claws and install the cowl side trim board.
  
  Fig 3: Identifying Cowl Side Trim Board Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the clip.
INSTALL FOOTREST CLIP (See INSTALLATION )
INSTALL FRONT FLOOR FOOTREST (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH
1. Engage the 14 claws and install the door scuff plate.
  
  Fig 4: Identifying Door Scuff Plate Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)