LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Highlander Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Brake Control System) >> Brake Control Power Supply >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Control Power Supply: Installation

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET 
  2. INSTALL NO. 2 BRAKE CONTROL POWER SUPPLY BRACKET 
  3. INSTALL NO. 3 BRAKE CONTROL POWER SUPPLY BRACKET 
  4. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY 
    1. Install the brake control power supply with the 4 bolts.

      Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

    2. Connect the brake control power supply connector.
      Fig 1: Installing Brake Control Power Supply Connector With Bolts
      G05189395Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH 
    1. Install the deck trim side panel RH (See INSTALLATION ) .

      HINT:

      Refer to the procedures from the installation of the deck trim side panel assembly RH up until the installation of the rear door scuff plate RH.

  6. INSTALL REAR SEAT CUSHION ASSEMBLY (See  INSTALLATION  ) 
  7. CHECK AND CLEAR DTC 
    1. Check and clear the DTC (see DTC CHECK / CLEAR  ).
scientia non olet · About LEMON Manuals