LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Highlander Base, 2.4 D, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Brake Control System) >> Skid Control Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Skid Control Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR WHEEL 
  2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (See  REMOVAL  ) 
  3. SEPARATE SKID CONTROL SENSOR WIRE 
  4. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE SKID CONTROL SENSOR 
    1. Install the 4 hub nuts to the 4 rear axle hub bolts. Placing an aluminum plate below the rear axle hub and bearing, place them into the vise.
      NOTE: Replace the rear axle hub and bearing if it is dropped or receives a strong shock.
    2. Using a pin punch (3 mm) or hammer, remove the 2 pins from SST (09520-00031) and separate the attachment (09521-00010).
    3. Using SST and 2 bolts (90101-12007), remove the sensor from the rear axle hub and bearing.

      SST 09520-00031 (09520-00040), 09521-00020, 09950-00020 

      NOTE:
      • Pull the sensor off straight, being careful not to make contact with the sensor rotor.
      • If the sensor rotor is damaged or deformed, replace the rear axle hub and bearing.
      • Do not scratch the area where the sensor contacts the rear axle hub and bearing.
      • Do not allow foreign matter to attach to the sensor rotor.
        Fig 1: Removing Sensor From Rear Axle Hub And Bearing
        G05189382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals