Inspection Procedure

1. Check door lock operation (See HOW TO PROCEED WITH TROUBLESHOOTING ).

NG: REPLACE DOOR LOCK 

OK : Go to Next Step 

1. Disconnect the TVIP ECU and door lock connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   LSWD (T3-37) - D11-8	Below 1 Ω
   LSWP (T3-38) - D12-7	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Identifying TVIP ECU And Passenger's Door Lock Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Disconnect the door lock connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   D11-7 - Body ground	Below 1 Ω
   D12-8 - Body ground	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Identifying Door Lock Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE