Inspection Procedure

1. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Switch Condition	Specified Condition
   -	LOCK	-
   1 - 3	ACC	Below 1 Ω
   1 - 2 - 3	ON	Below 1 Ω
   5 - 6	ON	Below 1 Ω
   1 - 2	START	Below 1 Ω
   4 - 5 - 6	START	Below 1 Ω

   Fig 1: Identifying Ignition Or Starter Switch Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE IGNITION OR STARTER SWITCH ASSEMBLY 

OK : Go to Next Step 

1. Remove the fuse from the instrument panel J/B.
2. Measure the resistance of the fuse.

   Standard resistance: 

   Below 1 Ω 

NG: REPLACE FUSE 

Fig 2: Identifying ECU-IG Fuse

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Remove the IG relay from the instrument J/B.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   3 - 5	10 kΩ or higher
   3 - 5	Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

NG: REPLACE RELAY 

Fig 3: Identifying Relay

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Disconnect the T3 TVIP ECU connector.
2. Turn the ignition switch ON.
3. Measure the voltage according to the value(s) in the table below.

   Standard voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   IG (T3-10) - Body ground	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 4: Identifying T3 TVIP ECU Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : REPLACE TVIP ECU