Inspection Procedure

1. Remove the security indicator.
2. Apply battery voltage and check that the security indicator turns on.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Measurement Condition	Specified Condition
   Battery positive (+) - Terminal 2 Battery negative (-) - Terminal 1	Security indicator turns on

NG: REPLACE SECURITY INDICATOR LIGHT ASSEMBLY 

Fig 1: Identifying Security Indicator Light Assembly Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Disconnect the TVIP ECU and security indicator connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   IND (T3-25) - (S4-2)	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Identifying TVIP ECU And Security Indicator Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Disconnect the security indicator connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   (S4-2) - Body ground	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 3: Identifying Security Indicator Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : REPLACE TVIP ECU