LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Tundra Base, 4.0 U >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (1GR-FE) - System Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring of the sensor.
    2. Install the sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      Fig 1: Locating Crankshaft Position Sensor Bolt
      G04968644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the sensor connector.
  2. CONNECT COOLER COMPRESSOR ASSEMBLY  (See INSTALLATION )
  3. INSTALL GENERATOR ASSEMBLY  (See INSTALLATION )
  4. INSTALL FAN AND GENERATOR V BELT  (See INSTALLATION )
  5. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
scientia non olet · About LEMON Manuals