Throttle Body: Installation

1. Install a new gasket onto the intake manifold.
   Fig 1: Locating New Intake Manifold Gasket

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle with motor body assembly using the bolt and 3 nuts.

   Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

   Fig 2: Locating Throttle Bolt & Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the water filler sub-assembly with hose using the 2 nuts.

   Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

   Fig 3: Locating Water Filler Sub-Assembly Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the wire harness with bracket using the nut.

   Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

5. Connect the throttle with motor body assembly connector.
   Fig 4: Locating Wire Harness Bracket Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect water by-pass hose No. 2.
   Fig 5: Locating Water By-Pass Hose No. 2

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the water by-pass hose.
   Fig 6: Locating Water By-Pass Hose

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install air cleaner cap sub-assembly with air cleaner hose No. 1.
2. Tighten the hose clamp to the specified torque.

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

   Fig 7: Locating Air Cleaner Assembly Clamp

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the wire harness clamp and mass air flow meter connector.
   Fig 8: Locating Wire Harness Clamp & Mass Air Flow Meter Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect ventilation hose No. 2.
   Fig 9: Locating Ventilation Hose No. 2

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the vacuum switching valve assembly connector and wire harness clamp.
6. Connect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 to the vacuum switching valve assembly.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)