Inspection Procedure
- CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0604)
- Connect Techstream to the DLC3.
- Turn the ignition switch on (IG).
- Turn the tester on.
- Clear the DTC.
- Turn the ignition switch off.
- Disconnect the negative battery terminal and wait for 1 minute.
- Connect the negative battery terminal.
- Turn the ignition switch on (IG).
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Result
RESULT CHARTDisplay (DTC output) Proceed to P0604 A No output DTC B
B : CHECK FOR INTERMITTENT PROBLEMS
A : REPLACE ECM (See ECM )