LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Corolla LE, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Navigation System) >> Navigation System >> How To Proceed With Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How To Proceed With Troubleshooting

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. VEHICLE BROUGHT INTO A WORKSHOP 
  2. DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION 
    1. Ask the customer about symptoms and confirm malfunctions.

    THE SCREEN DISPLAYS NOTHING (GO TO STEP   8 , AND PROCEED TO " BLACK SCREEN  ") 

    OTHER SYMPTOMS (GO TO STEP 3) 

  3. CONFIRM THE SYSTEM NORMAL CONDITION 

    APPLICABLE (THIS IS NOT A MALFUNCTION) 

    NOT APPLICABLE (GO TO STEP 4) 

  4. CHECK DTC 

    HINT:

    If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.

    A CODE IS OUTPUT (GO TO STEP 5) 

    A CODE IS NOT OUTPUT (GO TO STEP   8 ) 

  5. DTC CLEAR 
    1. Clear the DTCs and finish the diagnostic mode.

      HINT:

      The currently output DTCs may not indicate actual malfunctions depending on the vehicle conditions.

  6. RECHECK DTC 

    HINT:

    • If the system cannot enter the diagnosis mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits.
    • Even if the malfunction symptom is not confirmed, check for diagnostic trouble codes. This is because the system stores past diagnostic trouble codes.
    • Refer to the detailed description on the diagnostic screen, as necessary (See DIAGNOSIS DISPLAY DETAILED DESCRIPTION  ).
    • Check the diagnostic trouble code and inspect the area the code indicates.

    A CODE IS OUTPUT (GO TO STEP 7) 

    A CODE IS NOT OUTPUT (GO TO STEP   8 ) 

  7. DIAGNOSTIC TROUBLE CODE CHART 
    1. Find the output code on the diagnostic trouble code chart.

    NEXT: Go TO STEP  10

  8. PROBLEM SYMPTOMS TABLE 
    1. Find the applicable symptom code in the problem symptoms table.

      HINT:

      If the symptom does not recur and no code is output, perform the symptom reproduction method (See PROBLEM SYMPTOMS TABLE  ).

    THERE IS AN APPLICABLE SYMPTOM CODE IN THE TABLE (GO TO STEP   10 ) 

    THERE IS NO APPLICABLE SYMPTOM CODE IN THE TABLE (GO TO STEP 9) 

  9. CHECK THE ECU TERMINAL ARRANGEMENT BASED ON THE MALFUNCTION SYMPTOM 
  10. CHECK THE CIRCUIT 
    1. Adjust, repair, or replace as necessary.
  11. RECHECK THE DIAGNOSTIC TROUBLE CODE 

    HINT:

    After deleting the DTCs, recheck for diagnostic trouble codes.

  12. PERFORM CONFIRMATION TEST 

    NEXT: END 

scientia non olet · About LEMON Manuals