Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT STEREO COMPONENT AMPLIFIER

Fig 1: Inspecting Stereo Component Amplifier

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the stereo component amplifier connectors.

Measure the resistance according to the value(s) in the table below.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester connection

Condition

Specified condition

GND - Body ground

Always

Below 1 Ω

GND2 (⁽¹⁾), E (⁽²⁾) - Body ground

Always

Below 1 Ω

⁽¹⁾

for Coupe

⁽²⁾	for Convertible

Measure the voltage according to the value(s) in the table below.

Standard voltage

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester connection	Condition	Specified condition
+B2 - GND	Always	10 to 14 V
+B - GND	Always	10 to 14 V
ACC - GND	Ignition switch ACC	10 to 14 V

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE