LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System >> Yaw Rate And Deceleration Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Yaw Rate And Deceleration Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)  (See REMOVAL )
  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for 4WD)  (See REMOVAL )
  5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE YAW RATE AND DECELERATION SENSOR 
    1. Disconnect the yaw rate and deceleration sensor connector.
      2. Fig 1: Identifying Yaw Rate And Deceleration Sensor Connector And Bolts
      G05112388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and remove the yaw rate and deceleration sensor.
scientia non olet · About LEMON Manuals