Heated Oxygen Sensor: Installation

1. Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

   SST 09224-00010 

   Torque: 

   40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST 

   44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST 

   HINT:

   • Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
   • Make sure that SST and the wrench are connected in a straight line.
   Fig 1: Using SST To Install Heated Oxygen Sensor To Front No. 3 Exhaust Pipe Sub-Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

   SST 09224-00010 

   Torque: 

   40 N*m (408 kgf*cm, 30 ft*lbf) for use with SST 

   44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST 

   HINT:

   • Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
   • Make sure that SST and the wrench are connected in a straight line.
   Fig 2: Using SST To Install Heated Oxygen Sensor To Front Exhaust Pipe Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

See ON-VEHICLE INSPECTION

1. Install the 3 clamps, 6 bolts and the front floor cover LH.
   Fig 3: Identifying Front Floor Cover LH Clamps & Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002