LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System (Hybrid)) >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket onto the engine coolant temperature sensor.
    2. Install the engine coolant temperature sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Connect the engine coolant temperature sensor connector.
      4. Fig 1: Locating Engine Coolant Temperature Sensor Connector
      G05625743Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER BRACKET  (See INSTALLATION )
  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL NO. 2 ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  6. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  7. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY  (See INSTALLATION )
  8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  9. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY  (See INSTALLATION )
  10. INSTALL HOOD TO COWL TOP SEAL  (See INSTALLATION )
  11. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH  (See INSTALLATION )
  12. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH  (See INSTALLATION )
scientia non olet · About LEMON Manuals