Inspection Procedure

1. Disconnect the stop light switch assembly connector.
2. Measure the resistance according to the values in the table below.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Switch condition	Tester connection	Specified value
   Switch pin free	1 - 2	Below 1 Ω
   Switch pin free	3 - 4	10 kΩ or higher
   Switch pin pushed in	1 - 2	10 kΩ or higher
   Switch pin pushed in	3 - 4	Below 1 Ω

   Fig 1: Inspecting Stop Light Switch Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : GO TO NEXT STEP 

NG: REPLACE STOP LIGHT SWITCH ASSEMBLY 

1. Measure the voltage according to the value(s) in the table below.

   Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester connection	Condition	Specified condition
   S7-2 - Body ground	Always	10 to 14 V
   S7-3 - Body ground	Ignition SW ON	10 to 14 V

   Fig 2: Identifying Stop Light Switch Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : GO TO NEXT STEP 

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

1. Reconnect the stop light switch connector.
2. Disconnect the connector from the ECM.
3. Turn the ignition switch to the ON position.
4. Measure the voltage according to the value(s) in the table below.

   Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester connection	Condition	Specified condition
   E5-19 (STP) - Body ground	Brake pedal depressed	10 to 14 V
   E5-19 (STP) - Body ground	Brake pedal released	Below 1 V
   E5-12 (ST1-) - Body ground	Brake pedal depressed	Below 1 V
   E5-12 (ST1-) - Body ground	Brake pedal released	10 to 14 V

   Fig 3: Identifying ECM Connector E5 Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : REPLACE ECM 

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR