Throttle Body: Installation

INSTALL THROTTLE BODY
1. Install a new gasket to the intake air surge tank.
  
  Fig 1: Identifying Recess
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body and wire harness clamp stay to the intake air surge tank with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Identifying Throttle Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the control motor connector.
4. Connect the 2 water by-pass hoses to the throttle body.
Fig 3: Identifying Water By-Pass Hoses
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD ENGINE COOLANT (See REPLACEMENT )
CHECK FOR ENGINE COOLANT LEAKS (See ON-VEHICLE INSPECTION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )