Inspection Procedure

1. Disconnect the G6 connector.
2. Measure the resistance and voltage according to the value(s) in the table below.

   Resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   G6-7 (E) - Body ground	Always	Below 1 Ω

   Voltage 

   VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   G6-12 (BW) - Body ground	Always	10 to 14 V

   Fig 1: Identifying Multiplex Network Switch G6 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK : PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE