Cruise Control Main Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH
1. Install the cruise control main switch assembly with the 2 screws.
  Torque: 2.35 N*m (24 kgf*cm, 21 in.*lbf)
2. Connect the connector.
  
  Fig 1: Locating Cruise Control Main Switch Assembly With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal (See INITIALIZATION ).
INSPECT STEERING PAD (See INSTALLATION )
INSPECT SRS WARNING LIGHT
(See CHECK MODE PROCEDURE )