Laser Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL LASER SENSOR
1. Install the laser sensor so that the claw contacts the flat surface around the hole on the front bumper mounting reinforcement.
  NOTE: Do not insert the claw into the hole on the front bumper mounting reinforcement.
2. Engage the clamp.
3. Connect the connector.
INSTALL FRONT BUMPER REINFORCEMENT (See INSTALLATION )
INSTALL FRONT BUMPER ENERGY ABSORBER (See INSTALLATION )

Fig 1: Identifying Laser Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT BUMPER ASSEMBLY (w/o Fog Light) (See INSTALLATION )
INSTALL FRONT BUMPER ASSEMBLY (w/ Fog Light) (See INSTALLATION )
INSTALL RADIATOR GRILLE SUB-ASSEMBLY (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
VEHICLE PREPARATION FOR FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) (See ADJUSTMENT )
PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
INSPECT FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
ADJUST FOG LIGHT AIMING (w/ Fog Light) (See ADJUSTMENT )
ADJUST LASER SENSOR
(See ADJUSTMENT )