LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Avalon XLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Brake Control System) >> Rear Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Speed Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR WHEEL 
  2. DISCONNECT SKID CONTROL SENSOR WIRE 
    1. Disconnect the connector from the skid control sensor.
  3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH  (See REMOVAL )
  4. REMOVE REAR DISC 
    Fig 1: Locating Skid Control Sensor Connector
    G05001636Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH 
    1. Remove the 4 bolts and rear axle hub & bearing assembly.
      Fig 2: Locating Rear Axle Hub Bearing Assembly Bolts
      G05001637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR SPEED SENSOR 
    1. Mount the rear axle hub in a vise between aluminum plates.
      NOTE: Replace the axle hub & bearing assembly if it is dropped or receives a strong shock.
    2. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments (09521-00010) from SST.

      SST 09520-00031 

    3. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the rear speed sensor from the rear axle hub.

      SST 09520-00031 (09520-00040), 09521-00020, 09950-00020 

      NOTE:
      • If damage is inflicted on the sensor rotor, replace the axle hub & bearing assembly.
      • Do not scratch the contact surface of axle hub and speed sensor.
        Fig 3: Driving Out Pins
        G05001638Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals