LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - Circuit Tests And Service Information >> Throttle Body >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Throttle Body: Removal

  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  (See REMOVAL )
  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  4. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  5. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE AIR CLEANER HOSE ASSEMBLY  (See REMOVAL )
  7. REMOVE THROTTLE BODY ASSEMBLY 
    1. Disconnect the 2 water by-pass hoses.
    2. Disconnect the throttle position sensor and control motor connector.
      Fig 1: Locating Throttle Position Sensor And Control Motor Connector
      G05628220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts, throttle body and gasket.
    4. Remove the 2 water by-pass hoses from the throttle body.
scientia non olet · About LEMON Manuals