Brake Actuator: Removal

DISCONNECT VSC ACTUATOR CONNECTOR
1. Pull the release bar and disconnect the VSC actuator connector.
  NOTE: Be careful not to allow brake fluid to enter the removed connector.
  
  Fig 1: Pulling Release Bar
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE TUBE
1. Use tags or make a note to identify the reconnection locations.
  
  Fig 2: Identifying Brake Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.
  
  Fig 3: Identifying Union Nut Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.
  
  Fig 4: Locating Union Nut Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT BRAKE TUBE
1. Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.
2. Remove the clamp from the VSC actuator bracket.
  
  Fig 5: Locating Brake Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY
1. Remove the 3 nuts and VSC actuator with actuator bracket.
  NOTE: Do not damage the brake lines or wire harness.
  
  Fig 6: Locating VSC Actuator With Actuator Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002