Inspection Procedure
NOTE:
When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION
).
- RECONFIRM DTC
- Clear the DTC(s) (See DTC CHECK/CLEAR ).
- Turn the ignition switch to ON.
- Check if the same DTC is output (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC output A DTC not output B
B: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )