Cruise Control Main Switch: Inspection

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CRUISE CONTROL MAIN SWITCH

Remove the cruise control main switch (See CRUISE CONTROL MAIN SWITCH ).

Measure the resistance according to the value(s) in the table below.

Fig 1: Removing Cruise Control Main Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Identifying Cruise Control Main Switch Position

Standard Resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Switch Condition	Specified Condition
3 (CCS) - 1 (ECC)	Neutral	10 kΩ or higher
3 (CCS) - 1 (ECC)	+ (ACCEL)/RES (RESUME)	216 to 264 Ω
3 (CCS) - 1 (ECC)	- (COAST)/SET	567 to 693 Ω
3 (CCS) - 1 (ECC)	CANCEL	1386 to 1694 Ω
3 (CCS) - 1 (ECC)	Main switch on	Below 1.0 Ω

If the result is not as specified, replace the cruise control main switch.