Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
  
  Fig 1: Locating O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the camshaft position sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE: Make sure that the O-ring is not cracked or jammed when installing.
  
  Fig 2: Locating Camshaft Position Sensor With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the crankshaft position sensor connector and the 2 wire harness clamps.
  
  Fig 3: Locating Crankshaft Position Sensor Connector And Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL IDLE PULLEY ASSEMBLY WITH BRACKET (W/ AIR CONDITIONING)
1. Using several steps, uniformly install and tighten the 5 bolts in the sequence shown in the illustration.
  Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf) for bolt A
  
  43 N*m (438 kgf*cm, 32 ft.*lbf) for bolt B, C
INSTALL COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING) (See INSTALLATION )

Fig 4: Locating Idle Pulley Assembly With Bracket And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (W/ AIR CONDITIONING) (See INSTALLATION )
INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (for 4WD and Pre-Runner)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)