Rear Combination Light Assembly: Installation

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH sides.
The procedures listed below are for the LH side.

INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
1. Install the 3 bulbs and bulb sockets to the rear combination light.
2. Connect the connector and install the rear combination light.
3. Slide the 2 pins towards the back of the vehicle to install them.
4. Install the 2 nuts.
  
  Fig 1: Installing Rear Combination Light Assembly LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR COMBINATION LIGHT SERVICE COVER LH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.