LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Yaris Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Engine Control System) >> Camshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CAMSHAFT POSITION SENSOR 
    1. Install the sensor with the bolt.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the sensor connector.
  2. INSTALL INVERTER WITH CONVERTER 
    1. Install the inverter with converter (see INSTALLATION ).
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. ADD HV COOLANT  (See REPLACEMENT )
  5. ADD ENGINE COOLANT  (See COOLANT )
  6. INSPECT FOR COOLANT LEAK (for Engine)  (See ON-VEHICLE INSPECTION )
  7. INSPECT FOR COOLANT LEAK (for Inverter) 
  8. INSTALL RADIATOR SUPPORT OPENING COVER  (See INSPECTION  )
  9. INSTALL ENGINE UNDER COVER RH 
  10. INSTALL ENGINE UNDER COVER LH 
  11. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals