DTC P0604: Internal Control Module Random Access Memory (RAM) Error: Procedure
- CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0604)
- Connect Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTC.
- Turn the ignition switch off.
- Disconnect the negative battery terminal and wait for 1 minute.
- Connect the negative battery terminal.
- Turn the ignition switch to ON.
- Wait 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Result
Display (DTC output) Proceed to P0604 A No output DTC B
B → See step 2
A → See step 3
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
- REPLACE ECM. Refer to COMPONENTS